FILETO-Light weight Body Filler

Product Description

Fileto Polyester Putty is two components, Fast drying, fine pigmented polyester putty for general use in commercial vehicles. Good filling properties and easy to sand. This putty can also be applied directly over galvanized steel and aluminum surface.

Physical Properties

Performance Properties

Sand Time: 15 to 20 Minutes when mixed with 3 % hardener by weight @ 75°F (25°C)

SURFACE PREPARATION

Clean the repair area using soap and water followed by a wax & grease remover and surface cleaner. Sand the surface as needed with grade P150 or P180. Blow off with clean dry compressed air and re-clean the surface using a clean paper or cloth towel and a wax & grease remover and surface cleaner.

APPLICATION

1.      Apply the required amount of Fileto Polyester Putty to a clean mixing surface. (Do not use discarded cardboard as a mixing surface as contamination may occur.) Make sure to knead the hardener tube before using to insure a correct mix.

2.      Mix the Fileto Polyester Putty and cream hardener thoroughly, to a uniform color. Gel time and setting time is approximately 3-5 minutes @ 75 F using 3% hardener as prescribed. Spread the Putty on the mixing board, being sure to break any air bubbles that were introduced during mixing.

3.      Apply a thin layer using firm pressure to ensure maximum adhesion being sure to "wet out" the surface completely. Apply additional Putty in layers, building up the damaged area higher than the surrounding surface. Maximum Putty thickness should not exceed 1/8 inch. Allow curing time of 15 to 20 minutes.

4.      Sand the Putty to the proper contour with abrasives, using the following recommended grade sequence: P150, P180.

5.      Wait approximately 45 minutes before applying primer and paint, always follow your company’s recommended procedures.

STORAGE

Store in a dry area at 65-80°F(18-27°C) for optimal shelf life.

HANDLING

Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water. Keep out of the reach of children. Keep container closed when not in use. Avoid breathing of dust created by cutting, sanding, grinding or machining. For industrial or professional use only. Avoid eye contact with dust or airborne particles.

Precautionary Information

Refer to Material Safety Data Sheet for Health and Safety Information before using this product.